Manufacturers of high performance
hydraulic control solutions

SVCL10-32 Poppet, 3-Port, Normally Closed

SVCL10-32   Poppet, 3-Port, Normally Closed

SVCL10-32 Poppet, 3-Port, Normally Closed (SVCL10-32)

Item In Stock

Buy this product

Product Description

A solenoid-operated, normally-closed, on/off, poppet-type, screw-in hydraulic cartridge valve incorporating an integral load-sense pressure port with isolation check.

Product Operation

When de-energized, the SVCL10-32 blocks flow at ports 3 and 1. When energized, flow is allowed from 3 to 1 and 2 with a check-isolated load sense signal supplied at 2. Reverse flow is not allowed from 1 to 3.
NOTE: When using this valve in bridge circuits, seals should not be used on the pilot pistons of the pilot-operated check valves. This is to avoid trapping oil which would keep the pilot-operated check valve open.

Product Features

Continuous-duty rated solenoid.
Hardened precision spool and cage for long life.
Optional coil voltages and terminations.
Efficient wet-armature construction.
All ports may be fully pressurized.
Cartridges are voltage interchangeable.
Optional waterproof E-Coils rated up to IP69K.
Unitized, molded coil design.
Reduce manifold space claim.

Product Ratings

Operating Pressure: 250 bar (3625 psi); Holding Pressure at 1: 250 bar (5000 psi)
Flow: 15 gpm (57 lpm); see performance charts
Internal Leakage: Ports 1 and 3: 5 drops/minute max. at 250 bar (3625 psi)Port 2: 10 drops/minute max. at 250 bar (3625 psi)
Operating Temperature: -40° to 100°C (-40° to 212° F) with standard Buna N seals;-26° to 204°C (-15° to 400°F) with Fluorocarbon seals;-54°C to 104°C (-65°F to 225°F) with Polyurethane seals
Coil Duty Rating: Continuous from 85% to 115% of nominal voltage
Initial Coil Current Draw at 20°C: Standard D-Coil: 1.67 amps at 12 VDC; 0.18 amps at 115 VAC (full wave rectified). E-Coil: 1.7 amps at 12 VDC; 0.85 amps at 24 VDC
Minimum Pull-in Voltage: 85% of nominal at 207 bar (3000 psi)
Filtration: See page 9.010.1
Fluids: Mineral-based or synthetics with lubricating properties at viscosities of 7.4 to 420 cSt (50 to 2000 sus); See Temperature and Oil Viscosity, page 9.060.1
Installation: No restrictions; See page 9.020.1
Cavity: VC10-3, Variation “B”; See page 9.110.1
Cavity Tool: CT10-3XX; See page 8.600.1
Seal Kit: SK10-3X-MM; See page 8.650.1
Coil Nut: Part No. 7004400